News and information

                          News

                          Considerations when selecting hobs

                          2021-08-26 10:59:50 jiangxingTools 1051

                          Considerations when selecting hobs

                          1, Bore Dia.: using standard table(caution: tolerance of inch and metric)

                          2,Outside Dia.: usually using the standard table, however Outside Dia. can be increased for increasing productivity and fewer interruptions of maching( for high auto motive volumes: for M2.5, bore Multi-Gash(17-20N)

                          3,OAL(overall length): Per Massive volume, OAL can be increeased for up to maximum of Machine shift amount.

                          4,No. of Thread, select threads depending on cut type finishing.

                          5,No. of Flutes: Use 1 thread for Finishing Cutting, and use multi thread for roughing, or semi-topping.(When the number of gear teeth is divisible by no: threads, a profile error may result.)

                          6,Rake angle: Normally don't need.

                          7, Hand: Same direction as gear's.

                          8,GL: If hob lead angle is over 5 degrees, use spiral gashes.

                          9,Class: Normally use DIN A(Gear: JIS4-5)

                          10, Material: If high speed of hardness is required, Powder Material is used. Otherwise, M35(SKH55) is used.

                          免费无码黄级毛片,嫩草网址,久久久久免费看黄A级试看,国产自拍大香蕉